How Does No-Flat Work? (More FAQ’s)

When the vehicle is driven, the fluid action of the solution causes the entire inside treaded surface area of the tire to be coated with No-Flat. These adhesion properties keep the solution in place at all times and keep No-Flat ready to seal any source of air loss. It's that simple. The tire is now protected from any puncture or other leaks for the remaining legal life of the tire!
In the case of ATV’s or Lawn or Farm equipment, it will last many, many years.
A, flat tire prevention.
 
When a puncture occurs, the centrifugal force of the rotating tire and internal pressure forces No-Flat into the hole. A permanent seal is caused as the hole is packed with the fibers and other solids. Some of the material will go through the hole to the outside of the tire.
When this material is exposed to air, it dries and causes a permanent seal. When the puncturing object is removed, the vehicle should be driven in order to duplicate the above procedure. Once this has taken place, the seal is permanent and will last for the life of the tire.
Should the puncturing object be found after the tire was sitting for a long period of time, drive the vehicle before removing the puncturing object to allow the flat tire prevention to loosen up and spread. After about five (5) miles, remove the puncturing object and continue to drive.
No-Flat, flat tire prevention will easily seal holes up to one-quarter of an inch in diameter. Larger holes will normally seal if they are near the center of the tread area. A puncture that occurs while driving the vehicle will seal almost instantly and very little air will be lost before a permanent seal is made. Many times You Will Not Even Know, you, ‘would have had’, a flat tire.
No-Flat, flat tire prevention also helps to dissipate the heat caused by road friction. This allows the tire to run much cooler; as a result of proper air pressure and cooler operating temperatures, you can get up to 30% more life from your tire. AND, Better Gas Milage !!!!

Characteristics of No-Flat  (More FAQ’s)

This space-age product is a solution with natural fibers, artificial fibers, adhesion agents, drying agents, corrosion inhibitors, anti bacterial, and other solids.

It is designed to keep the fibers and solids in constant suspension. Because there is no settling of the solids and fibers, No-Flat tire life enhancer is always ready to work for you -- no mixing, stirring, or other preparation are necessary.

The adhesion properties in No-Flat, flat tire prevention -- coupled with the fact that it remains fluid when installed in the tire -- provides constant protection for all parts of the tire. Aerosol inflators provide temporary fixes at best.

No-Flat, flat tire prevention is thixotropic. That is, it thins rapidly when the motion increases, thereby maintaining an even layer of No-Flat, flat tire prevention on all surfaces. Clean up is simple, just rinse with water.

No-Flat is ready for use. NO mixing or special preparation is required. In fact, No-Flat formulation is non-toxic, non-flammable, and environmentally friendly.

No-Flat also does not void tire manufacturer warranties or affect wheel balance if properly installed.

(More FAQ’s)